An Exoneuromusculoskeleton for Self-Help Upper Limb Rehabilitation After Stroke.

Journal: Soft robotics
Published Date:

Abstract

This article presents a novel electromyography (EMG)-driven exoneuromusculoskeleton that integrates the neuromuscular electrical stimulation (NMES), soft pneumatic muscle, and exoskeleton techniques, for self-help upper limb training after stroke. The developed system can assist the elbow, wrist, and fingers to perform sequential arm reaching and withdrawing tasks under voluntary effort control through EMG, with a lightweight, compact, and low-power requirement design. The pressure/torque transmission properties of the designed musculoskeletons were quantified, and the assistive capability of the developed system was evaluated on patients with chronic stroke ( = 10). The designed musculoskeletons exerted sufficient mechanical torque to support joint extension for stroke survivors. Compared with the limb performance when no assistance was provided, the limb performance (measured as the range of motion in joint extension) significantly improved when mechanical torque and NMES were provided ( < 0.05). A pilot trial was conducted on patients with chronic stroke ( = 15) to investigate the feasibility of using the developed system in self-help training and the rehabilitation effects of the system. All the participants completed the self-help device-assisted training with minimal professional assistance. After a 20-session training, significant improvements were noted in the voluntary motor function and release of muscle spasticity at the elbow, wrist, and fingers, as indicated by the clinical scores ( < 0.05). The EMG parameters ( < 0.05) indicated that the muscular coordination of the entire upper limb improved significantly after training. The results suggested that the developed system can effectively support self-help upper limb rehabilitation after stroke. ClinicalTrials.gov Register Number NCT03752775.

Authors

  • Chingyi Nam
    Department of Biomedical Engineering, The Hong Kong Polytechnic University, Hong Kong, China.
  • Wei Rong
    Interdisciplinary Division of Biomedical Engineering, The Hong Kong Polytechnic University , Hong Kong.
  • Waiming Li
    Interdisciplinary Division of Biomedical Engineering, The Hong Kong Polytechnic University, Hung Hom, Hong Kong.
  • Chingyee Cheung
    Department of Biomedical Engineering, The Hong Kong Polytechnic University, Hong Kong, China.
  • Wingkit Ngai
    Industrial Centre, The Hong Kong Polytechnic University, Hong Kong, China.
  • Tszching Cheung
    Industrial Centre, The Hong Kong Polytechnic University, Hong Kong, China.
  • Mankit Pang
    Industry Centre, The Hong Kong Polytechnic University, Hung Hom, Hong Kong.
  • Li Li
    Department of Gastric Surgery, Sichuan Clinical Research Center for Cancer, Sichuan Cancer Hospital & Institute, Sichuan Cancer Center, Affiliated Cancer Hospital of University of Electronic Science and Technology of China, Chengdu, China.
  • Junyan Hu
    Institute of Textile & Clothing, The Hong Kong Polytechnic University, Hung Hom, Hong Kong.
  • Honwah Wai
    Industry Centre, The Hong Kong Polytechnic University, Hung Hom, Hong Kong.
  • Xiaoling Hu
    Interdisciplinary Division of Biomedical Engineering, The Hong Kong Polytechnic University, Hung Hom, Hong Kong. Xiaoling.Hu@polyu.edu.hk.